Accessoires
Neumann TLM 170 R
Description
- Large diaphragm microphone
- Omnidirectional/wide cardioid/cardioid/hypercardioid/eight
- Pure, linear, flexible: the professional solution for every recording situation
- 5 directional characteristics, optionally remote controllable
- Very low noise and distortion
- Enormous dynamic range of 130 dB
- Extremely versatile
- 48V Phantom
- XLR-3M
- nickel
The TLM 170 R is a universal studio microphone for the highest demands. It combines top technical performance with the euphony of a large-diaphragm capsule. The TLM 170 R works extremely linearly in all five directional characteristics. With the optional N 248 power supply, the directional behavior can be controlled remotely.
Features:
- Versatile studio microphone for vocals and instruments
- High dynamic range of 130 dB
- Very low inherent noise
- Flat frequency response in all five polar patterns
- Directional characteristics can optionally be controlled remotely
Technical data
- Acoustic mode of operation: Pressure gradient receiver
- Directional Pattern: Omnidirectional, Wide Cardioid, Cardioid, Hypercardioid, Figure Eight
- Transmission range: 20 Hz ... 20 kHz
- Field transfer factor at 1 kHz at 1 kOhm: 8 mV/Pa ± 1 dB
- Nominal impedance: 50 ohms
- Nominal load impedance: 1 kOhm
- Substitute noise level, CCIR 1: 26 dB
- Replacement noise level, A-weighted 2: 14 dB-A
- Limit sound pressure level for k < 0.5% 3: 144 dB
- Limit sound pressure level for k < 0.5% with pre-attenuation 4: 154 dB
- Noise level ratio, CCIR (rel. 94 dB SPL) 5: 68 dB
- Noise level ratio, A-weighted (rel. 94 dB SPL) 6: 80 dB
- Maximum output voltage: 10 dBu
- Power supply (P48, IEC 61938): 48 V ± 4 V
- Current consumption (P48, IEC 61938): 3 mA
- Required connector: XLR 3 F
- Weight: 625g
- Diameter: 60 mm
- Length: 152 mm
2) according to IEC 60268-1; CCIR rating according to CCIR 468-3, quasi-peak value; A rating according to IEC 61672-1, effective value
3) measured as equivalent electrical input signal
4) measured as equivalent electrical input signal
5) according to IEC 60268-1; CCIR rating according to CCIR 468-3, quasi-peak value; A rating according to IEC 61672-1, effective value
6) according to IEC 60268-1; CCIR rating according to CCIR 468-3, quasi-peak value; A rating according to IEC 61672-1, effective value