Audio Tools

Dap Audio ADI-200 - Aktive DI-Box

  • Roadproof housing with rubber feet
  • Low distortion
  • Ground lift
  • 20dB Attenuation switch
Item no.: D1943

Palmer Pro PAN 02 - DI-Box aktiv

Standard active DI box. Can be operated with 9 V batteries or 48 V phantom power. High-impedance input; higher output level than with a passive DI box. Active circuitry allows for high input impedance ( 1 meg. ohm) and higher input sensitivity (typical difference between in and out -4 dB). Maximum output impedance with phantom power operation +10 dB. Output: transformer balanced. The special "floating ground" circuitry enables ground lift even during phantom power operation. Metal case 110 x 73 x 42 mm.


  • No. of channels: 1
  • Passive/Actibe: Active
  • Transformer balanced: Yes
  • Attenuator: -30 dB
  • Power Supply: 9V / 48V
  • Input/Output Gain: -4 dB
  • Ground lift switch: Yes
  • Max Input Level: +45 dBu
  • Max Output Level: +10 dBu
  • Frequency Range @ 2K Source Imp. -1dB: 10 Hz - 20 kHz
  • Input Impedance @ 60Hz: 1 MΩ
  • Nom. Output Impedance: 600 Ω
  • Housing: Steel
  • Dimension: 110 x 73 x 42 mm
Item no.: ADHPAN02

Dante AVIO-AES3/EBU-Adapter

  • Impedanz 110 O (sym.)
  • Signal/Rauschabstand > 135 dB
  • Sample-Rate 44,1/48/96 kHz, 24 Bit
  • Anschlüsse 1 x RJ45, 1 x XLR-Stecker, 1 x XLR-Kupplung
Item no.: M0259640

Dap Audio Cable Tester Pro

  • Must have for every roady
  • 9V Battery operated
  • Speakon 4P, Speakon 8P, RJ45, RCA
  • XLR 3P, XLR 5P, 5P Din, 6,3 Jack, 3,5 Jack
Item no.: D1909

Dap Audio Digital Sound Level Meter

LCD Digital-Display
? Analog Bar Anzeige
? Breite Dynamik
? Auto/Manual Bereich
? Schnelle/Langsame Response wählbar
? Max. Wert Hold-Funktion
? A/C-Weighting Auswahl
? Datum und Zeit Display
? AC/DC Auxilitary-Output
? Hintergrundbeleuchtetes Display
? Low-Power Anzeige
Item no.: 91004

Dap Audio FLA02 - Jack M. (50 kilo-Ohm) > XLR M. (600 Ohm) - Mit Impedanzanpassung und Ein/Aus-Schalter

  • With impedance-matching and on/off switch
Item no.: FLA02

Dap Audio FLA03 - Jack F. (50 kilo-Ohm) > XLR F. (600 Ohm) - Mit Impedanzanpassung und Ein/Aus-Schalter

  • With impedance-matching and on/off switch
Item no.: FLA03

Dap Audio XLR Female to XLR Male - (isoliert)

  • (insulated)
Item no.: FLA09
Contact person

Audio Tools

An event can only be running smoothly if all of the cables are working properly. If, at any point, one might be suspecting a faulty cable, simply use our cable testers. With them you will quickly get to the root of the problem.

The same goes for speakers; they should be tested before every event. Our speaker checkers by Showtec are sure to be up to the task.

We also offer the solution to many other problems. With a DI unit you can connect devices with high impedance, unbalanced signals (instruments) to devices with low impedance, balanced signals (mixers). This minimises the probability of encountering interferences.

So have a look at our range of audio tools!